Extremely cold temperatures can cause pipes to get frozen. This may cause pressure inside the pipe which leads to a burst or may also cause flooding. The effective way to prevent pipes from bursting is to keep them warm and at a normal temperature. At the time of cold weather ruptured pipes are the common causes of the damage and this can easily cost around $5,000 or even more to repair. Here are some of the best ways to keep water lines from freezing.

Maintain the Temperature

To maintain the temperature at the house keep the heat on even while going out for a long time. This may cost for utility bills but by doing this pipes can be prevented during the cold weather. In case the pipes freeze and burst it may cause a lot of water damage for property and to their possessions. It is not necessary to keep the heat on at a high temperature but keeping it above 50 F is more preferable. This can provide enough heat to keep the pipes warm and to prevent them from freezing. So always keep the property at a normal temperature.

Leave the Faucet to Drip

You can allow the faucet to drip to avoid the pipe to get cold. By keeping the faucet open helps in avoiding the pressure formed in the pipe. When pressure is between that can cause blockage and have a high chance of burst. Keeping the faucet open helps If the faucet is used by hot and cold water pipes keeping it open slightly. You can also set a single-handle faucet like the kitchen taps to keep warm.

Close the Cracks and Holes

Make sure there are no gaps and holes where pipes pass through the walls or floors mainly where there is more chance of cold air getting inside the house. It is better to Use caulk and spray foam insulation like Great Stuff to fill the gaps. Sealing the holes internally and externally is much better to avoid the cold air. Getting in these cold air can make a cabinet compartment pretty cold, even colder.

Apply Heating Tape

The heating tape helps to keep the pipe warmer and prevent against freezing of pipes. Providing heat directly to the pipe can keep it warm during cold weather. This is a great solution to prevent a small section of pipes from getting cold. Two types of heating tape are available. One of them turn on and off by itself when the heat is need. Another type is manual; they should be turned on when the heat is required they don’t have an automatic switch.

Add Extra Insulation

The pipes which are in locations like basements or attics need extra insulation pipes to keep the pipe away from freezing. They can be fit along with rubber and fiberglass sleeves. This could be a great and easy solution to the pipes that are exposed. These are some of the few solutions that can prevent the pipes from getting frozen during the cold season. Hire Plumber Darling Point for every type of pipe plumbing.